Change Currency: EUR

Change Language: DeutschDanskEnglish (UK)English (US)EspañolFrançaiseDutch

El Cheapo 10 amp controller


Product Information

GX 10A Brushless ESC


To choose another option, you need restart from step 1.

Options Table 1 (for Aircraft version Normal mode):



(with 0.5s break)

Option 1

–, –


Cell Type:


Auto detect LIPO cells and set LIPO

protection cut-off;

Slow down at 3V per cell of LiPo, Cut-50%


cut-off at 2.9V per cell LiPo.

(option 2, will be disabled automatically)

Option 2

– – , – –


Cell Type:


(Default setting)

Select NIMH protection mode

Cut-to 50% power when voltage lower to

60% of starting voltage (0.72V each cell of


(option 1 will be disabled automatically)

Option 3

– – – , – – –










Working Voltage: 2S-3S LiPo or 4-9 NiCd/NiMh



Load continues: 10 Ampere (with proper cooling)

Load Peak: 15A (10 sec)

BEC: 2A at 5V.

PWM: 8 Khz

Dimensions: 23.5x15.7x6.1mm

Weight: 8 Gram

Programming Instructions:

1. Connect your motor and receiver to the speed controller, but do not connect the battery


2. Turn on your transmitter and full up the throttle stick. Please Note: Most Futaba

transmitters have the throttle channel reversed by default.

3. Connect your battery and you will hear a starting beep tone. After 3 seconds, the motor

will start beeping a sequence as following. All beeps repeat only once.

4. To select, move the throttle stick in off position, between Beeps repeat. Then you will

hear a confirmation sound.

5. Each time when you select an option, it will exit programming menu and is ready to use.

Product Code: ELU9

Customer Reviews

This product hasn't been reviewed yet. Write a review


Copyright RBCkits 2019-2020

RBCkits uses cookies. For more detailed information about these cookies please see our privacy policy. Please accept to continue or block all non-essential cookies.

I accept cookies from this site.

eCommerce by CubeCart